The dry mixed thin layer masonry mortar is made of polymer, organic admixture and other materials by a certain proportion through a specific process. The more common application is the wall that we often see. It is necessary to add this kind of material. What are its performance characteristics? Jinan plastering mortar manufacturer will introduce it to you.

　　薄層砌筑砂漿產品性能特點:

　　Performance characteristics of thin layer masonry mortar:

　　1. 薄層砌筑砂漿產品特性:

　　1. Product characteristics of thin layer masonry mortar:

　　使用非常方便，加水即可攪拌;高保水性;鍵的強度;高耐候性;抗裂性好，收縮率低;防火和隔熱。

　　It is very convenient to use, and can be stirred with water; high water retention; bond strength; high weather resistance; good crack resistance, low shrinkage; fire prevention and heat insulation.

　　2. 薄層砌筑砂漿應用范圍:

　　2. Application scope of thin layer masonry mortar:

　　薄層砌筑及抹灰層厚度一般為3~5mm，抹灰厚度不得超過8mm。

　　The thickness of thin layer masonry and plastering layer is generally 3-5mm, and the plastering thickness shall not exceed 8mm.

　　3.抹過程:

　　3. wipe the process:

　　門窗框架四周填縫→墻面清洗→垂直掛、方、抹灰糕、打孔補強→濕墻(內外)→薄層砌筑砂漿施工→維護→驗收。

　　Caulking around the door and window frame → wall cleaning → vertical hanging, square, plastering cake, drilling and reinforcement → wet wall (inside and outside) → thin layer masonry mortar construction → maintenance → acceptance.

　　A)清理基面雜物?；鶎颖砻鎽?yīng)清潔、不松動、無灰塵、無油脂等。松動和開裂的部分應提前鑿出并修補，以免影響粘結強度。夏季施工或基層墻面較干燥時，施工時可適量先灑水濕潤，及內濕外干即可。

　　A) Clean up the sundries on the base surface. The surface of the base course shall be clean, free from looseness, dust, grease, etc. Loose and cracked parts shall be chiseled out and repaired in advance to avoid affecting the bond strength. In summer, when the construction or the base wall surface is relatively dry, the construction can be watered properly first, and the internal humidity and external dryness can be achieved.

　　B)剪力墻界面進行基底粗化處理。提前用高壓水槍沖洗表面，清除界面浮塵，第二天進行薄層抹灰。

　　B) The interface of shear wall is roughened. Wash the surface with high-pressure water gun one day in advance, remove the floating dust on the interface, and carry out thin plastering the next day.

　　C)薄層抹灰施工時，宜存活一次，厚度不得大于5mm。

　　C) During thin layer plastering construction, it is better to survive once, and the thickness shall not be greater than 5mm.

　　D)施工中與不同材料連接時，應粘貼耐堿玻纖網布。

　　D) When connecting with different materials during construction, alkali resistant glass fiber mesh shall be pasted.

　　E)地表水收集后及時進行表面處理。

　　E) Surface treatment shall be carried out in time after surface water collection.

　　F)薄層灰漿抹面施工完成后，可以自然養護，當環境異常干燥時可進行澆水養護。

　　F) After the construction of thin-layer mortar plastering is completed, it can be cured naturally. When the environment is abnormally dry, it can be cured by watering.

　　薄層砌筑砂漿的性能特點如上所述，更多相關內容咨詢，濟南抹面砂漿廠家歡迎您的咨詢。

　　The performance characteristics of thin-layer masonry mortar are as described above. For more information, welcome to Jinan plastering mortar manufacturer.